Shutter: LINMOT - SETUP
=======================

IMACS-laptop (Win2000) start the LinMot application:
 -> Login
 -> Control -> STOP
 -> Para (meter editor)

Note: '!' denotes 'not' 
The drive configurations are identical EXCEPT drives
 'A' and 'C' have check=0
while
 'B' and 'D' have check=300

System-> StartupMode-> !AutoStart
      -> CommandI/F -> ASCII-RS232

Drives-> A-> Type-> P0x-37 
          -> Init-> Mode->     AutoMove-In
                 -> Switches-> !InitOnce
                 -> Config->   Speed=48.8      [mm/s]
                          ->   MaxCur=100      [%]
                          ->   Home=0.0        [mm]
                          ->   Check=0.0       [mm]
                          ->   InitialPos=0.0  [mm]
          -> ValueGen-> RunMode-> Serial
                     -> ValueConfig-> MinPos=0.0   [mm]
                                   -> MaxPos=356   [mm]

         B-> Type-> P0x-37
          -> Init-> Mode->     AutoMove-In
                 -> Switches-> !InitOnce
                 -> Config->   Speed=48.8      [mm/s]
                          ->   MaxCur=100      [%]
                          ->   Home=0.0        [mm]
                          ->   Check=300       [mm]
                          ->   InitialPos=0.0  [mm]
          -> ValueGen-> RunMode-> Serial
                     -> ValueConfig-> MinPos=0.0   [mm]
                                   -> MaxPos=356   [mm]

         C-> Type-> P0x-37
          -> Init-> Mode->     AutoMove-In
                 -> Switches-> !InitOnce
                 -> Config->   Speed=48.8      [mm/s]
                          ->   MaxCur=100      [%]
                          ->   Home=0.0        [mm]
                          ->   Check=0.0       [mm]
                          ->   InitialPos=0.0  [mm]
          -> ValueGen-> RunMode-> Serial
                     -> ValueConfig-> MinPos=0.0   [mm]
                                   -> MaxPos=356   [mm]

         D-> Type-> P0x-37
          -> Init-> Mode->     AutoMove-In
                 -> Switches-> !InitOnce
                 -> Config->   Speed=48.8      [mm/s]
                          ->   MaxCur=100      [%]
                          ->   Home=0.0        [mm]
                          ->   Check=300       [mm]
                          ->   InitialPos=0.0  [mm]
          -> ValueGen-> RunMode-> Serial
                     -> ValueConfig-> MinPos=0.0   [mm]
                                   -> MaxPos=356   [mm]